Read current and temperature
| Verwendung |
|
Read temperature, voltage and current
Monitoring during operation
I want to keep an eye on current, voltage, and temperature at the factory.
Can these values be queried directly from TC?
Booster Station
Silvio Richter describes in the forum:
The prerequisite is the Booster operating station and a block assigned to the operating station in the FDL.
A button assigned to this block is used as an operation to assign values to a numerical variable (context booster).
The current is read in mA, the temperature and voltage as a three-digit number.
The result could then look like this:
- fig: Booster-Strom
Divide variable by 10
The 3-digit temperature value must be divided by 10 for the display.
- Fig: Temperature divided by 10
I have a signalman press the button every 3 seconds. This way, I always have a real-time view of the power consumption and temperature of the control unit, and I can also set limits and trigger further actions.
Weblinks
- Quelle: Forum
- TC-wiki: Z21; Achtung bei Anschluss der Booster 10806 und 10807
- TC-wiki: Roco Dual Booster über CAN-Bus
- -- Uslex 12:39, 24. Jul. 2026
