Quelltext der Seite Betriebsstelle Lokwechsel oder Rangierbereich/en

<languages/>
__NOTOC__

{{TC10g}}

<span id="Betriebsstelle_Lokwechsel"></span>
== locomotive changeover depot ==

<span id="Lokwechsel_ohne_Ausfahrt"></span>
=== Locomotive change without exit ===

I want to use the locomotive change operating point to drive a locomotive up to the rear of the train. How do I go about it?

:
[[Datei:Betriebsstellen.png|400px]]
:''Fig: Operating points''

<span id="Lokwechsel_oder_Rangierbereich"></span>
=== locomotive change or shunting area ===

Mr. Freiwald writes about this in [https://www.freiwald.com/forum/viewtopic.php?p=271983#p271983 forum]

At the '''operating station locomotive change''' the locomotive is changed. This means:

* a locomotive is separated from the incoming train,
* drives out
* and another locomotive drives in
* and is added to the train. 

Therefore, not only an '''entry block''' is always required, but also an '''exit block''' over which the separated locomotive can exit.

If it is only a matter of bringing a locomotive in and adding it to a train, the '''shunting area operating point''' can be used for this purpose.

== Weblinks ==

* Those: [https://www.freiwald.com/forum/viewtopic.php?p=271983#p271983 forum]
*TC-wiki: [[Special:MyLanguage/Schneller Aufrücken|Faster advancement]]


:--‎ [[Special:MyLanguage/Benutzer:Uslex|Uslex]] ([[Benutzer Diskussion:Uslex|Diskussion]]) 18:11, 2. Jan. 2025 (CET)

[[Kategorie:Software{{#translation:}}]]
[[Kategorie:TrainController{{#translation:}}]]
[[Kategorie:Betriebsstelle{{#translation:}}]]