Einstellung der richtigen Signalbilder/en

Verwendung

Signal images in TC

Signal images in the software

A very common question is: How do I set the correct signal images in the software?

Users of TrainController often report that the signals cannot be controlled correctly or that the desired signal aspect is only displayed correctly "very briefly".

Only one control command

This is mostly due to the fact that a signal decoder only needs one control command per signal aspect - and TrainController, when using the default settings, always sends two; first the "correct" one and then an "incorrect" one, which ultimately results in an incorrect signal aspect.

Giorgio has provided an illustrated explanation on www.gotthardmodell.ch.

Fig: not like this - four-aspect signal

The first image shows the default setting - for the signal aspect "green", two switching commands are sent (namely "address 1 green" and then "address 2 green") - and the signal decoder then implements this - how should it know that this is not desired?

Fig.: Four-aspect signal

Im zweiten Bild wird pro Signalbegriff nur noch ein Schaltbefehl gesendet - und siehe da, auch der Signaldecoder und schlussendlich das Signal zeigen den korrekten Signalbegriff an.

Hinweis: Je nach Digitalsystem werden die Kontakte «rot/grün» oder mit «Plus/Minus»-Zeichen dargestellt.

Weblinks

• Signale: www.gotthardmodell.ch

-- Wohlmannstetter 08:53, 27. Sep. 2017‎

bearbeitet: Uslex 17:24, 16. Feb. 2022 (CET), Uslex (Diskussion) 16:43, 21. Dez. 2025 (UTC)