Signal images with Stärz decoder
Aus RailRoad&Co.-Wiki
| Verwendung |
|
Signal images
Connection example for 2, 3 & 4-term signals
The following examples demonstrate how to connect signals to the Stärz LDMiba 3D (operating mode 1) and WDMiba (without dimming function) decoders. In collaboration with a friend who is an electronics engineer, additional circuit boards were developed that allow 3- and 4-aspect signals to be connected to fewer outputs. Assembly instructions for these boards can be found at the end of this document.
- Fig: decoder LDMiba 3D
One of our Swiss friends sent us these instructions as a PDF: Signale_LDMiba3.pdf for connecting light signals to decoders from Stärz (Selectrix).
Further information regarding connection assignment in the case of Selectrix is available in the forum.
Weblinks
- Quelle: Forum
- Anleitung: Signale_LDMiba3.pdf
- TC-wiki: Signale in TrainController
- -- Wohlmannstetter 09:23, 13. Feb. 2011
- bearbeitet: Uslex 12:37, 1. Feb. 2022 (CET), Uslex (Diskussion) 16:09, 21. Dez. 2025 (UTC)
