Aktion nach Halt auslösen/en: Unterschied zwischen den Versionen
Die Seite wurde neu angelegt: „At one of the regional regular meetings of users of TrainController the following solution was shown to activate operations even after a train has stopped and restarted in a block. By using this method sounds, actions etc. can be executed even after a train needs to stop within the block, but before it reaches the following block - even after a stop has occurred. Normally, action markers after the stop mark are not executed if the train set must stop at t…“ |
Die Seite wurde neu angelegt: „=== Flagman within the block ===“ |
||
| Zeile 13: | Zeile 13: | ||
At one of the regional regular meetings of users of TrainController the following solution was shown to activate operations even after a train has stopped and restarted in a block. By using this method sounds, actions etc. can be executed even after a train needs to stop within the block, but before it reaches the following block - even after a stop has occurred. Normally, action markers after the stop mark are not executed if the train set must stop at the stop mark | At one of the regional regular meetings of users of TrainController the following solution was shown to activate operations even after a train has stopped and restarted in a block. By using this method sounds, actions etc. can be executed even after a train needs to stop within the block, but before it reaches the following block - even after a stop has occurred. Normally, action markers after the stop mark are not executed if the train set must stop at the stop mark | ||
< | <span id="Bahnwärter_im_Block"></span> | ||
=== | === Flagman within the block === | ||
:[[Datei:TC-Haltmarkierung-Bild1.jpg|150px]] | :[[Datei:TC-Haltmarkierung-Bild1.jpg|150px]] | ||
Version vom 11. Oktober 2025, 12:41 Uhr
| Verwendung |
|
Trigger action after stop
Operations after Stopping
At one of the regional regular meetings of users of TrainController the following solution was shown to activate operations even after a train has stopped and restarted in a block. By using this method sounds, actions etc. can be executed even after a train needs to stop within the block, but before it reaches the following block - even after a stop has occurred. Normally, action markers after the stop mark are not executed if the train set must stop at the stop mark
Flagman within the block
Abb: Haltemarkierung
Wenn ein Zug in einem Block anhält, so werden Aktionsmarkierungen, welche entfernungsmäßig hinter der Haltemarkierung liegen bei erneuter Anfahrt des Zugverbandes nicht mehr ausgelöst.
Dieses Problem lässt sich mittels eines Bahnwärters lösen, welcher in den Block eingefügt wird.
Komplette Anleitung lesen
Die komplette Beschreibung findet sich auf der Webseite von Sarguid: www.naechternhausen.de .
Weblinks
- Quelle: www.naechternhausen.de
- TC-wiki: Aktionsmarkierung
- -- Sarguid (Diskussion) 20:24, 13. Dez. 2023 (UTC)
- bearbeitet: Uslex (Diskussion) 08:29, 15. Dez. 2023 (UTC)
