Set up control car

Aus RailRoad&Co.-Wiki
Version vom 29. März 2026, 07:44 Uhr von Uslex (Diskussion | Beiträge) (Die Seite wurde neu angelegt: „It is essential to check whether this car triggers a contact – if so, the ''No Contact'' option must be deactivated. Otherwise, a pushed train will stop inaccurately!“)
Zur Navigation springenZur Suche springen
Verwendung
thumbs


Control car

Question

How do I set up a control car for TrainController?

Control car as locomotive

The setting "locomotive" is also correct for a control car. From the perspective of the control logic, a control car is an intermediate device between a locomotive and a carriage, but with much more similarity to a locomotive than to a carriage.

A control car can "pull" a train, i.e., run at the front of a train, without the train becoming a "pushed" train in terms of control logic.
A control car responds to directional commands like a locomotive.
A control car has a driver's cab like a locomotive.

The only difference is that a control car has no drive mechanism. Therefore, it has more similarities than differences to a locomotive than to a carriage.

Even in its prototype, a control car is a "stripped-down substitute locomotive". Its control logic would remain practically unchanged if one were to eliminate the only difference to a locomotive and install a drive system.

However, if one were to eliminate the difference to a car and remove the driver's cab, much more serious operational differences would result, even in the prototype.

A control car is essentially a locomotive with 0 kW of drive power.


Control car in TrainController from version 11 onwards

TraniController Version 11 users may have noticed that control cars are now a subgroup of cars and can be used separately in descriptions.

If the control car is registered as a locomotive, the "wrong-way driving bit" must be set in CV 29 (read CV29 value +1). This makes the control car react in exactly the opposite way to the locomotive at the front of the train.

However, the checkbox in the function library only applies to operation in the driver's cab, not to operations in automatic mode.

Carriages also have two sides, A and B. In control cars, the driver's cab is installed on side A (i.e., at the front). If a train consists of a control car and the driver's cab is at the rear, then the car, viewed from the outside, will move backward when the train is pulled.


Control car in TrainController from version 8 onwards

In the properties of a car, it can be designated as a control car: simply activate the corresponding Control Car checkbox!

Fig.: Control car contact

It is essential to check whether this car triggers a contact – if so, the No Contact option must be deactivated. Otherwise, a pushed train will stop inaccurately!

Steuerwagen unterscheiden sich durch normale Wagen übrigens durch folgende Eigenschaften:

  • Sie können auch Fahrtrichtungsbefehle an einen zugeordneten Decoder senden. Auf diesem Wege ist es möglich, fahrtrichtungsabhängige Funktionen (z.B. Stirnbeleuchtung oder Rücklicht) auch an einem Wagen zu schalten.
  • Wenn sie in einem Zugverband enthalten sind, so können sie genau wie Loks auch im Lokführerstand ausgewählt werden, um die Geschwindigkeit und Fahrtrichtung des gesamten Zugverbands zu steuern.


Steuerwagen in TrainController bis Version 7

Silvo Richter hat folgenden Beitrag zur Verfügung gestellt. Anlass war dieser Beitrag:

Steuerwagen mit eigenem Decoder sind in TC Gold als Lokomotive einzurichten.

Sie ähneln einer Lok wesentlich mehr als einen Wagen mit dem Unterschied, dass er keinen Motor hat und somit keine Leistung.
  • Als Leistung ist 1 kW zu hinterlegen.

Warum nicht als Wagen?

  • Man kann zwar in Wagen Decoderfunktionen hinterlegen, doch wird kein Fahrtrichtungswechsel generiert und das verhindert den Lichtwechsel rot-weiß.
Wenn der Zugverband durch eine Lok-Wagen-Lok-Kombination eingerichtet ist, werden ebenfalls die Zugfahrtsregeln Nur rückwärts/vorwärts starten umgangen, was auch gewollt ist.
Schließlich kann ein Wendezug auch geschoben werden.


Funktionsweiterleitung

Zu diesem Thema gibt es weitere Beiträge:

  • In diesem Beitrag geht es um den Punkt "Funktionsweiterleitung" - Spitzen- und Schlusslicht am Steuerwagen.
  • siehe auch hier im TC-Wiki unter Funktionsweiterleitung



--Digi thomas2003 13:23, 1. Mär. 2014 (CET)
bearbeitet: Uslex 09:40, 4. Jun. 2022 (CEST), Uslex (Diskussion) 12:49, 15. Dez. 2025 (UTC)