Hardware/en: Unterschied zwischen den Versionen
Aus RailRoad&Co.-Wiki
Zur Navigation springenZur Suche springen
Uslex (Diskussion | Beiträge) KKeine Bearbeitungszusammenfassung |
Übernehme Bearbeitung einer neuen Version der Quellseite |
||
| (3 dazwischenliegende Versionen von 2 Benutzern werden nicht angezeigt) | |||
| Zeile 11: | Zeile 11: | ||
===Digital system=== | ===Digital system=== | ||
{{ | {{TC7891011gsb}} | ||
The digital system establishes the connection between the PC and the model railway. | The digital system establishes the connection between the PC and the model railway. | ||
| Zeile 47: | Zeile 47: | ||
The list of hardware manufacturers is by no means complete. Manufacturers are listed as soon as there is at least one TC wiki article/experience report related to TrainController. | The list of hardware manufacturers is by no means complete. Manufacturers are listed as soon as there is at least one TC wiki article/experience report related to TrainController. | ||
=== CdB: CAN-digital-Bahn === | |||
:* [[Special:MyLanguage/CdB Hardware Ausfall|CdB Hardware failure]] | |||
===ECoS - ESU=== | ===ECoS - ESU=== | ||
Aktuelle Version vom 9. November 2025, 17:46 Uhr
Hardware
Digital system
| Verwendung |
|
The digital system establishes the connection between the PC and the model railway.
- digital system
- setting up a digital system
- replacing the digital system
- delete digital system (One of two digital systems is replaced)
- Systems and devices for control with Traincontroller
Digital centers
communication processes between digital system and TC
- Configure IP address with permanently connected hardware
- TC -- Model Railway Layout: "Knowledge" and Communication
- Connection to the digital system is disconnected
- Digital systems .... a comparison
- Which digital systems are supported by Traincontroller?
- Is there a comparison table between the individual digital control centers?
- Changes when changing the digital system
- Error codes when opening a connection to the digital system
- network connection TCP or UDP
- Delete digital system
- Digital voltage difference central - booster
Control panels with SX protocol
Hardware manufacturers
The list of hardware manufacturers is by no means complete. Manufacturers are listed as soon as there is at least one TC wiki article/experience report related to TrainController.
CdB: CAN-digital-Bahn
ECoS - ESU
LDT - Littfinski DatenTechnik
Lenz
Loconet
- Loconet feedback and display after TC start
- Loconet messages delayed Digikeijs DR4088LN
Märklin
- Märklin CS2
- Märklin CS3
PIKO
Rautenhaus
Roco
- Z21 - WLan connection
- Z21 - WLan activation code
- Z21; Attention when connecting the boosters 10806 and 10807 Caution: risk of short circuit!
- Roco Z21 Detector
- Roco feedback module 10787; Programmierung
- Programming the Roco 8-way switch decoder with TamsEasyControll
- LDT DB-4 combined with Roco MultizentralePro
- Digikeijs DR4088RB-CS programming combined with Z21
- Rocomotion interface 10785
- MultimausPro; Expansion to 29 locomotive functions
- Roco Multimaus brakes switch circuit
- Roco CV change values; parental control
- Firmwareupdate Rocomotion 5.9
Uhlenbrock
- Intellibox I
- Problems with resetting the IB and driver installation
- Intellibox II
Stärz ZS2
Tams digital systems
Viessmann
YaMoRC (Digikejs)
µCon-s88-Master FW 1.6
Zimo
Model railway-PC
The Railroad & Co. software family supports the Windows operating system.
PC-Hardware
- computer with multi-core processor
- Changing computers, what should I do?
- USB Hub
- Connection problems under Windows 10
- USB drivers for Windows 64 Bit
- USB COM in Windows 11
screen resolution monitor
- screen resolution scaling monitor
USB stick
- USB stick in delivery state
- My USB stick doesn't work anymore, what should I do?
- Problems with Windows Update
+SmartHand
+SmartHand is a hand control system for model railways that was specially designed for use with TrainController.
+SmartHand Classic
+SmartHand Mobile
feedback detectors, occupancy detectors, contact detectors
Blocks and detectors
- Momentary detector or permanent detector; a comparison
- block with three detectors
- Maximum section length with occupancy detector
Detector
- Establishment of the LDT-HSI88
- Establishment of the HSI-88 for three-wire
- Feedback with Märklin C-and-K-track
- 8-way IR track occupancy detector for S88
- Reporting axles, feedback for wagons
RailCom
- Identification of several vehicles in a block (via RailCom)
- Train control with RailCom
- RailCom - Train identification - locomotive direction
- RailCom with two decoders
- Identification of unregistered locomotives
Decoder
Preparing locomotives for TC
- Decoder braking delay
- Decoder speed profile - Setting minimum, average and maximum speed
- Recalibration when replacing the control unit
Switches
- frog polarization of switches
- Double crossing switch with two drives
- Monitoring of the switch position does not work, why?
- Monitoring the switch position with RailCom
Signals
Turntables, transfer tables
- Ich möchte eine Setting up a transfer table, how does it work?
- Turntable with TC-Silver
- Turntable Decoder Programming
- Minitrix transfer table 66540
- transfer table with locomotive decoder
- 7686 Turntable Programming englisch! (TC70G)
- Digikeijs 5052 - Turntable Programming
- Configuration of a turntable with DSD2010 from Sven Brandt
- Märklin-Turntable Programming
Booster
- Boostermanagement with DR5033 Version TC 9
- Boostermanagement with Uhlenbrock Power4 Version TC 9
- Digital voltage difference central - booster
- Roco Dual Booster over CAN-Bus
